PT - JOURNAL ARTICLE AU - Paprottka, Karolin Johanna AU - Lehner, Sebastian AU - Fendler, Wolfgang P. AU - Ilhan, Harun AU - Rominger, Axel AU - Sommer, Wieland AU - Clevert, Dirk A. AU - op den Winkel, Mark AU - Heinemann, Volker AU - Paprottka, Philipp Marius TI - Reduced Periprocedural Analgesia After Replacement of Water for Injection with Glucose 5% Solution as the Infusion Medium for <sup>90</sup>Y-Resin Microspheres AID - 10.2967/jnumed.115.170779 DP - 2016 Nov 01 TA - Journal of Nuclear Medicine PG - 1679--1684 VI - 57 IP - 11 4099 - http://jnm.snmjournals.org/content/57/11/1679.short 4100 - http://jnm.snmjournals.org/content/57/11/1679.full SO - J Nucl Med2016 Nov 01; 57 AB - The primary aim of our study was to compare the need for periinterventional on-demand analgesia when water for injection (WFI) was replaced with glucose 5% (G5) for 90Y-resin microsphere administration. Methods: Forty-one patients who received 77 radioembolization procedures with G5 (2014–2015) were retrospectively matched with 41 patients (77 radioembolization procedures) who received radioembolization with WFI (2011–2014) at our center. The need for on-demand pain medication was chosen as an objective and accessible measure of periprocedural pain experienced by patients. Results: Patients were well matched according to sex, age, tumor type and involvement, and prior antiangiogenic therapies. Periinterventional analgesic requirements were significantly lower for radioembolization procedures performed with G5 than WFI: 5 of 77 (6.5%) versus 29 of 77 (37.7%), P ≤ 0,001, respectively. Early stasis (defined as slowed antegrade flow, before total vascular stasis) occurred in 12 of 154 (7.8%) radioembolization procedures overall and was not different (P ≤ 0.229) between the 2 groups (4/77 [5.2%] vs. 8/77 [10.4%]). Conclusion: Slow pulsatile administration of 90Y-resin microspheres with WFI is associated with a low rate of stasis. Replacement of WFI with G5 significantly reduces the need for periprocedural analgesia. These data favor the use G5 for 90Y-resin microsphere implantation in daily practice.